Filter
Top Products
Xerox WorkCentre PE120i System Administration Guide Page 5-3
AppleTalk
AppleTalk Installation
Installation Procedure
There are two stages required to install the WorkCentre PE120i on an AppleTalk network:
¾ Network Communication Setup
This requires the WorkCentre PE120i to be setup for AppleTalk.
¾ Print Driver Installation
¾ Test Print
A test print should be submitted to ensure the WorkCentre PE120i has been
installed and configured correctly.
Network Communication Setup
This procedure is used to setup the network communication parameters of the WorkCentre
PE120i.
At the WorkCentre PE120i, perform these steps:
HINT: Xerox CentreWare Internet Services can also be used to configure the
WorkCentre PE120i, refer to the Internet Services chapter for instructions.
¾ Connect the device to the network outlet or cable.
1
2
¾ Press [Menu] until you see
Network Setup on the top line of
the display.
8. Network Setup
[Reset Network]