Filter
Top Products
Xerox WorkCentre PE120i System Administration Guide Page 2-7
Basic Network Installation
Manually setting TCP/IP Addresses
At the WorkCentre PE120i, perform these steps:
HINT: Xerox CentreWare Internet Services can also be used to configure the
WorkCentre PE120i, refer to the Internet Services chapter for instructions.
When manually making the TCP/IP settings, you will need to know the following information:
¾ The IP address.
¾ The subnet mask, if required.
¾ The Gateway address, if required
1
¾ Press [Menu] until you see
Network Setup on the top line of
the display.
8. Network Setup
[Reset Network]
2
¾ Press or until Configure
Network is displayed and press
[Enter].
8. Network Setup
[Config Network]
33
¾ Press or until TCP/IP is
displayed and press [Enter].
Config Network
[TCP/IP]