Filter
Top Products
47
Operations
Load Ribbon
6/29/11 110PAX4/R110PAX4 User Guide 57512L-004 Rev. A
Figure 16 • Loaded Ribbon
To load ribbon, complete these steps:
1. Place a full ribbon roll (1) onto the ribbon supply spindle (2) so that the ribbon rotates as
shown, and then push the roll toward the print engine frame until it is fully seated.
Caution • While performing any tasks near an open printhead, remove all rings, watches, hanging
necklaces, identification badges, or other metallic objects that could touch the printhead. You are not
required to turn off the printer power when working near an open printhead, but Zebra recommends it as a
precaution. If you turn off the power, you will lose all temporary settings, such as label formats, and you must
reload them before you resume printing.
Left-Hand Right-Hand
Left-Hand Right-Hand
2
1
2
1