Filter
Top Products
Configuration
Control Panel Parameters
84
57512L-004 Rev. A 110PAX4/R110PAX4 User Guide 6/29/11
Set Applicator Port Mode
Determines the action of the applicator port.
Note • Set this value as suggested by the applicator manufacturer.
Default: OFF
Selections: OFF, MODE 1, MODE 2, MODE 3, MODE 4
• OFF: The applicator port is off.
• MODE 1: Asserts the ~END_PRINT signal low while the
print engine is moving the label forward.
• MODE 2: Asserts the ~END_PRINT signal high while the
print engine is moving the label forward.
• MODE 3: Asserts the ~END_PRINT signal low for 20 milliseconds
when a label has been completed and positioned. Not asserted during
continuous printing modes.
• MODE 4: Asserts the ~END_PRINT signal high for 20 milliseconds
when a label has been completed and positioned. Not asserted during
continuous printing modes.
To change the value shown:
1. Press the left or right oval to scroll through the options.
Set Applicator Error Signal When Print Engine Pauses
When this option is enabled and the print engine is paused, the print engine
sets the applicator error state.
Default: ENABLED
Selections: ENABLED, DISABLED
To change the value shown:
1. Press the left or right oval to toggle between the options.
Table 7 • Print Engine Parameters (Page 21 of 25)
Parameter
Action/Explanation
APPLICATOR PORT
- OFF +
ERROR ON PAUSE
- ENABLED +