Filter
Top Products
81
Configuration
Control Panel Parameters
6/29/11 110PAX4/R110PAX4 User Guide 57512L-004 Rev. A
Set Delimiter Character
The delimiter character is a two-digit hex value used as a parameter place
marker in ZPL/ZPL II format instructions. See the ZPL II Programming
Guide for more information.
Note • Do not use the same hex value for the control, format, and
delimiter character. The print engine must see different characters
to work properly.
Default: 2C (comma)
Range: 00 to FF
To change the value shown:
1. Press the left oval to move to the next digit position.
2. Press the right oval to increase the value of the digit.
Select ZPL Mode
The print engine remains in the selected mode until it is changed by this
parameter or by using a ZPL/ZPL II command. The print engine accepts
label formats written in either ZPL or ZPL II, eliminating the need to
rewrite any ZPL formats that already exist. See the ZPL II Programming
Guide for more information on the differences between ZPL and ZPL II.
Default: ZPL II
Selections: ZPL II, ZPL
To change the value shown:
1. Press the left or right oval to toggle between the options.
Select Media Power-Up Option
This parameter sets the action of the media when you turn on the
print engine.
Default: CALIBRATION
Selections: FEED, CALIBRATION, LENGTH, SHORT CAL, and NO
MOTION
• Feed—feeds the labels to the first registration point.
• Calibration—determines the length of the label and adjusts the
sensor settings.
• Length—In continuous mode, feeds the last stored label length. In
noncontinuous mode, calibrates based on the maximum label length
setting (see Set Maximum Label Length on page 68).
• Short Cal—calibrates label length using the current sensor settings.
• No Motion—the media does not move. You must press
FEED to
cause the print engine to resynch to the start of the next label.
To change the value shown:
1. Press the left or right oval to scroll through the options.
Table 7 • Print Engine Parameters (Page 18 of 25)
Parameter
Action/Explanation
DELIMITER CHAR
- <,>2CH +
ZPL MODE
- ZPL II +
MEDIA POWER UP
- CALIBRATION+