Filter
Top Products
146 Zebra ZXP Series 8 Card Printer with Laminator P1013372-001 Rev. A
Setting Custom Card Specifications
Adjustments
B.4.2 Partial Transfer
Front of card
Partial transfer is usually caused by lack of energy being transferred to the card, i.e. the
temperatures are too low or the speeds are too fast.
Step 1. Increase Front Transfer Temperature:
a. From the Card Specifications window, make a note of the default front transfer
temperature settings; see Section B.3.
b. Increase the appropriate (single or double side) front transfer temperature by 5.
c. Click on the OK button.
d. Print a test card; see Section B.3.
e. Examine the test card.
• If there is noticeable improvement, continue increasing the front transfer
temperature by 5, printing a test card, and examining the resulting card. Stop
when the problem is corrected or there is no more improvement. If the
problem is corrected, no more adjustment is required; otherwise go to Step 2.
• If there is no noticeable improvement, return the temperature to its default
setting; and go to Step 2.
Light or missing transfer on
the sides
Spotty transfer anywhere on
the card
Light transfer on entire card