Filter
Top Products
Operation
Operator Control Panel (OCP)
P1013372-001 Rev. A Zebra ZXP Series 8 Card Printer with Laminator 53
Operational
Operational Messages are displayed during the Printer’s normal operation.
MESSAGE DESCRIPTION
ALARM An error message needs to be cleared before normal operations
can resume.
CANCELING The Cancel button was pressed, and the current operation is
being terminated.
CONFIG DATA Configuration data is being transferred from the computer to
the printer.
CONTACT OPERATION Contact Smart Card is being encoded; i.e., the card is in position
and data is being transferred.
CONTACTLESS OPERATION Contactless Smart Card is being encoded; i.e., the card is in
position and data is being transferred.
COOLING Ready to accept a print job, rollers cooling; e.g., when switching
from 2-sided printing to 1-sided printing.
COOLING
PRINT JOB WAITING
Print job received, cooling rollers to temperature.
COOLING
PRINTHEAD TEMPERATURE
Cooling printhead to temperature.
COOLING
WAITING TO LAMINATE
Ready to accept a print job, laminator cooling; e.g., when
switching from 2-sided laminating to 1-sided laminating.
DIAGNOSTIC Diagnostic testing in progress.
JOB DATA Data is being transferred from the computer to the printer.
LAMINATING Print job received, laminating in process.
MAG OPERATION A Magnetic Stripe Card is being encoded; i.e., card is in position
and data is being transferred.
MANUALLY INSERT CARD
FROM FRONT
Waiting for manual card feed (this function is set via the Card
Setup Tab on page 73).
OFFLINE Status toggled (offline/online) via the
OCP Advanced
Settings Menu.
PRINTING Print job received, printing in process.
READY Ready and at temperature.
STANDBY Printer is in “sleep” mode; i.e., power save mode.
WAIT
INITIALIZING
Performing a self test on startup.
WARMING Ready to accept a print job, rollers heating; e.g., at startup or
when switching from 1-sided printing to 2-sided printing.
WARMING
PRINT JOB WAITING
Print job received, warming rollers to temperature.
WARMING
WAITING TO LAMINATE
Ready to accept a print job, laminator warming; e.g., when
switching from 1-sided laminating to 2-sided laminating.
WARMING
PRINTHEAD TEMPERATURE
Warming printhead to temperature.
WARNING Indicates that additional
OCP instructions need to be performed;
e.g.,
PRINT RIBBON LOW, etc.