Filter
Top Products
Programming
Text Commands
48
P1003638-003 TTP 8000 Technical Manual 10/19/2009
Print commands
This command makes the printer print the contents of the line buffer.
Text is converted from text to pixel lines and stored in the line buffer when an <LF> is
received. If the line buffer is empty when <ESC>p is received, nothing is printed.
Text to be printed <LF><ESC>p prints "Text to be printed" on the paper.
Printout occurs automatically at:
This command makes the printer generate a self-test page based on the current parameter
settings and print that page. The parameter values printed are the ones currently being used.
They can differ from Power-ON default values if for example a printout from Windows has
been done before ESC P is sent to the printer. To make a self test printout with the Power-ON
default settings, power up the printer with the Feed button pressed.
The value n1 n2 represents high byte and low byte of the number of dot lines the paper is to be
transported forwards. Minimum value is 0, and maximum value is 32767.
• For 203 dpi printers, a dot line is 0.125 mm, and 32767 equals approximately 4.1 m.
• For 300 dpi printers, a dot line is 0.0833 mm, and 32767 equals approximately 2.7 m.
• For 203 dpi printers a dot line is 0.125 mm, and 255 dot lines equal approximately 32 mm.
• For 300 dpi printers, a dot line is 0.0833 mm, and 255 dot lines equal approximately 21.25
mm.
ESC p
Print
1B 70 Hex
27 112 Decimal
Cut <RS> and <ESC><RS>
Form feed <FF>
Clear presenter <ENQ>
Run presenter <ESC><FF><n1>
Print buffer full
Press on Feed
button
ESC P n1
Print Self-test Printout
1B 50 n1 Hex
27 80 n1 decimal
n = 0 Gives standard self-test printout.
n = 1 Gives a character set printout using the font selected by parameter p14.
ESC Q
Quick Advance
1B 51 n1...n2 hex
27 81 n1...n2 Decimal