Filter
Top Products
Product Presentation
Indicators
12
P1003638-003 TTP 8000 Technical Manual 10/19/2009
Indicators
The status indicator flashes in various sequences to indicate specific statuses or warnings.
The status indicator (see Figure 3, Printer Exterior, Rear View, on page 11) has several
functions:
Status-codes are reset:
• When the conditions causing them are removed.
• When the printer is turned off/on.
• When the printhead is lifted and then lowered. On printers without printhead lifted sensor,
remove paper, install again, and press the Feed button to reset.
• When the hardware reset command is received.
ON constantly The printer is operational.
Flashes rapidly Indicates error. Hold down the feed-forward button and the number of
flashes will reflect the status-code. See Table 1.
Flash, pauses,
flash
Indicates warnings of non-severe error. The number of flashes reflects
the warning-code. See Table 2.
Table 1 • Status Codes
Number of
Flashes
Status Code Description
1
Paper jam in presenter
2
Cutter cannot return to home position
3
Out of paper
4
Printhead lifted
Note • Only available on printers with printhead open sensor
installed.
5
Paper wrapped around platen (under head)
6
Temp error, printhead is above 60°C
7
Presenter not rotating
Fast flashes
Checksum error, firmware
Steady light
Wrong firmware type
Off
No firmware is loaded, or wrong firmware checksum