Filter
Top Products
Default Parameter Settings
Fixed Document Mode
86
P1003638-003 TTP 8000 Technical Manual 10/19/2009
You can lock the parameters so that they cannot be changed by the ESC & P command.
Adds a delay between the burning of blocks in the printhead. This delay helps possible for the
power supply to recover from the heavy load of heating pixels. If you have a somewhat weak
power supply, print quality can be enhanced by increasing this value. A high value slows the
printout down slightly.
Recommended settings: 0 for 300 W (12.5 A) PSU, 255 for 150 W (6.5 A PSU)
53
0Default
Lock Parameters
0 Min
1Max
<ESC>&P<53><0> Unlocked
<ESC>&P<53><1> Locked
55
255 Default
PSU Recovery
0 Min
255 Max