Filter
Top Products
79
Default Parameter Settings
Print Setup
10/19/2009 TTP 8000 Technical Manual P1003638-003
Stores 16 different TAB stop positions. The position is set in increments of 2.5-mm.
Tab position 255 sets a tab stop on the last position of the line. Use this if you want underline
or reversed text to extend across the full paper width.
To set all tab stops at once, use Set Horizontal Tabs on page 43.
To move a single tab stop, use the set parameter command <ESC>&P. for example:
Default positions are one TAB on each cm; that is parameter values 4, 8, 12 etc. to 64.
Sets the speed at which the paper is ejected / retracted. 1 = 45 mm/s, 40 = 1.8 m/s
Carriage Return and Line Feed can be interpreted in five different ways to suit different
operating systems.
15 to 30
-Default
Tab Stop
1 Min
255 Max
Example • <ESC>&P<15><10> set the first tab stop 25 mm from the left margin.
31
20 Default
Pull Speed
1 Min
40 Max
Note • Vertical versions of the printer have n31 set to 2 on firmware versions up to 3.21 and
to 1 for firmware versions 3.28 and above.
33
0Default
CR/LF Behavior
0 Min
4Max
Note • v=0 is suitable for Windows, v=1 for UNIX, v=2 for DOS, and v=4 for Macintosh
<ESC>&P<33><0> LF = CR/LF CR = Ignored
<ESC>&P<33><1> LF = CR/LF CR = CR
<ESC>&P<33><2> LF = LF CR = CR
<ESC>&P<33><3> LF = LF CR = CR/LF
<ESC>&P<33><4> LF = Ignored CR = CR/LF