Filter
Top Products
Default Parameter Settings
Fixed Document Mode
84
P1003638-003 TTP 8000 Technical Manual 10/19/2009
When the printout is printed and cut, the presenter ejects about 50 mm of the page so that the
customer can grab it. If the kiosk wall is thick, or if you just want a longer part of the printout
to be visible, this parameter adds extra eject length.
Sets the width of the paper loaded into the printer. This can also be used to get left and right
margins, for instance if you load A4 paper but set the paper width to 170 mm you get a 20 mm
margin on both sides of the page.
47
0Default
Wall Compensation (mm)
DRV
0 Min
127 Max
<ESC>&P<47><50> Adds 50 mm extra eject = about 100 mm in
total.
Note • The resolution of the sensor is ± 3 mm so small changes in the parameter setting may
not show.
Longer ejects are more accurate than shorter ones because acceleration and retardation of the
rollers affects the eject less. Allow for ± 10 mm variations on short ejects.
48
208 Default
Paper Width (mm)
DRV
58 Min
216 Max
Note • The page width is not changed until the parameters are stored in the flash PROM with
the command <ESC>&<4>
. So you cannot change paper width within a page.
<ESC>&P<48><208><ESC>&<4> Sets A4 width
<ESC>&P<48><214><ESC>&<4> Sets Letter width
Note • We recommend you to set max 208 for A4 and max 214 for letter to allow the paper to
wander a bit sideways without losing print.