Filter
Top Products
85
Default Parameter Settings
Fixed Document Mode
10/19/2009 TTP 8000 Technical Manual P1003638-003
Selects if the cut command cuts at the position where the paper is at, or if the printer should
advance the paper before cutting.
Set to 1 if the printer is used in text mode and 0 if it is used from a driver that takes care of this
in the driver.
This parameter is used by command ESC # to store the calibration of the black mark sensor.
Normally there is no need to set this parameter manually.
0 is white and 255 is pitch black (out of paper).
Turns on/off indication of Paper Near End and Weekend paper level on the status indicator
(Figure 3, Printer Exterior, Rear View, on page 11) . This affects only the status indicator, not
the status enquiries.
49
1Default
Bottom Margin
DRV
0 Min
1Max
<ESC>&P<49><0> Off
<ESC>&P<49><1> Automatic Distance Calculation
<ESC>&P<49><2> Feed 2 mm
<ESC>&P<49><255> Feed 255 mm "Automatic Distance
Calculation" means advancing the paper
with the Head-To-Cutter distance (19 mm on
the TTP 8000 series).
Note • The paper is advanced before the FF command calculates the page length to see if the
page length is longer than the set minimum length.
51
50 Default
Black Mark Sensitivity
0 Min
255 Max
Note • This parameter is not available on printers with hardware revision A of the control
board. The revision is printed on the test printout.
52
0Default
Warning Level
0 Min
255 Max
<ESC>&P<52><0> No indication
<ESC>&P<52><1> Paper Near End indication
<ESC>&P<52><2> Weekend level indication
<ESC>&P<52><3> Paper near end and weekend indication