Filter
Top Products
27
Operation
Installing a Paper Roll
10/19/2009 TTP 8000 Technical Manual P1003638-003
Using Auto Load
1. Make sure the printer is turned ON.
2. Make sure the front edge of the paper is straight.
3. Enter the paper between the guide wings and feed it straight into the printer.
4. The platen should grip the paper, feed one form length, cut and eject, and set the printer
online.
Using Manual Load
1. Open the printhead by pulling the two release levers back and tilt up the printhead.
Figure 14 • Manual load of new paper
2. Position the paper on the shelf so that it passes the rubber platen roller.
3. Close the printhead. Remember to push the printhead release levers forward. Note that the
paper must be between the guides (circled in the above picture), and under the black plate
(arrow).
Note • Autoloading works if the printer is on, the head is down and locked, and the Paper
Out flashing sequence is showing on the status indicator. If you see that the paper does not
pull straight, press the Feed button to stop the loading, then straighten the paper, and press
the button again to commence.