Filter
Top Products
Fanfold Media Loading
Fanfold media, from outside the printer, feeds through either the bottom or
rear access slot. You may also use the Fanfold Supply Bin to hold media
inside the printer housing.
To load fanfold media, thread the media through the Printhead Assembly as
shown in Figure 3. Adjust the Media Guide against the outer edge of the
media. This guide must not cause pressure or excessive drag on the media.
Close the Printhead Open Lever, and turn to “Transmissive Media Sensor
Position Adjustment” on page 15.
10 Zebra XiII-Series User’s Guide
TEAR-OFF
C
UTTER
BOTTOM SUPPLY REAR SUPPLY
Figure 3. Fanfold Media Loading
22
H:...Xi2UsersGuideR2.vp
Fri Aug 07 10:34:43 1998
Color profile: Disabled
Composite Default screen