Filter
Top Products
The Transmissive Media Sensor consists of two sections. The media passes
between a light source (Lower Media Sensor) and a light sensor (Upper
Media Sensor).
This adjustment aligns the position of the Upper and Lower Media Sensors
with the notch or edge of the label.
Adjusting the Upper Media Sensor Position
NOTE: If you own a 140XiII or 170XiII printer and need to move the
sensor to the outside half of the maximum media width, or from
the outside half to the inside half, contact a service technician to
perform this procedure because it will require additional steps
which are beyong the scope of this user’s guide.
To adjust the upper media sensor, follow these steps.
1. Remove ribbon if it is installed.
16 Zebra XiII-Series User’s Guide
UPPER
MEDIA SENSOR
ADJUSTMENT
Figure 4. Upper Media Sensor Adjustment
28
H:...Xi2UsersGuideR2.vp
Fri Aug 07 10:34:44 1998
Color profile: Disabled
Composite Default screen