Filter
Top Products
Removing the Label Backing Material
(Rewind Option Required)
Since the Backing Rewind Spindle holds the backing from a standard-size
media roll, we recommend that you perform this procedure whenever you
change the media.
To remove the backing material from the Backing Rewind Spindle, follow
these steps (you don’t need to turn the printer power off for this procedure).
1. Unwind about one yard (one meter) of backing from the Backing
Rewind Spindle and cut it off at the spindle.
2. Pull out the Spindle Hook and slide the backing material off of the
spindle and discard.
3. Wind the media around the Rewind Spindle once or twice and reinstall
the Spindle Hook. Continue winding to remove any slack in the media.
Transmissive Media Sensor
Position Adjustment
When the XiII printer is powered on, it performs a self test and configures
its operating characteristics. Some of these characteristics are determined
by the position of the Transmissive Media Sensor. The factory-set position
is sufficient for most types of media. However, if media sensor position
adjustments are needed, follow the procedures below.
NOTE: The Reflective (Black-Mark) Media Sensor position is not
adjustable; it is positioned to accommodate all black-mark media
that meets the specifications listed in “Media Specifications” on
page 81.
NOTE: If you are using continuous media (no gap, notch, or hole between
labels) or black-mark media, position the transmissive sensor over
the media so that the printer can detect an out-of-paper condition.
The factory-set position should be sufficient for this purpose.
Zebra XiII-Series User’s Guide 15
27
H:...Xi2UsersGuideR2.vp
Fri Aug 07 10:34:43 1998
Color profile: Disabled
Composite Default screen