Filter
Top Products
4. Align the upper end of the Rewind Plate with the corresponding open
-
ing in the Side Plate and slide the Rewind Plate in so that it stops
against the printer’s main frame.
5. Load the media as described in the instructions for Roll Media Loading
on page 9. When loading the media, allow about one yard of media to
extend past the Tear-Off bar. If using label stock remove all labels
from this portion of the media to create a leader.
6. Remove the Spindle Hook from the Rewind Spindle. If you are using a
core, remove all tape from the core and slide it onto the Rewind Spindle
until it is flush against the guide plate.
7. Route the media as shown in Figures 1 and 2 and wind it once or twice
around either (1) the Rewind Spindle and reinstall the Hook, or (2) a 3"
core. (With some media, especially tag stock, you may need to tape the
end of the media to the core if it will not otherwise tighten onto the
core. DO NOT tape the label stock unless absolutely necessary.)
NOTE: Before closing the Printhead Open Lever, make sure that the
following guidelines are met:
the media is positioned against the inside guides, and the outer guide
and Media Supply Guide barely touch the media
the media is taut
the media is parallel with itself and with the pathway when wound on
the Rewind Spindle/core
8. Media loading is now complete. See “Transmissive Media Sensor
Position Adjustment” on page 15.
Rewind Mode for Printers With the Cutter Option
1. Remove the Media Rewind Plate from its storage location in front of
the print mechanism inside the media compartment.
2. Invert the Rewind Plate so that the lip on the attached Hook Plate points
down.
12 Zebra XiII-Series User’s Guide
24
H:...Xi2UsersGuideR2.vp
Fri Aug 07 10:34:43 1998
Color profile: Disabled
Composite Default screen