Filter
Top Products
Adjusting the Print Darkness
This procedure sets the darkness of the printing on the label. Use the
lowest setting which provides the necessary print quality.
1. Press the MODE key. PAUSE and DARKEN lights turn ON.
2. Press UP or DOWN to adjust the current setting.
3. Press the MODE key three times. The MODE lights will flash ON and
OFF to indicate that the settings have been saved in memory.
4. Press PAUSE to exit PAUSE mode. PAUSE light turns OFF.
Adjusting the Media Rest Position
This procedure sets the end-of-label position relative to the Tear-Off
Bar or Cutter.
1. Press the MODE key twice briefly. PAUSE and POSITION lights turn
ON.
2. Press UP or DOWN to adjust the current setting.
3. Press the MODE key twice briefly. The MODE lights will flash ON
and OFF to indicate that the settings have been saved in memory.
4. Press PAUSE to exit PAUSE mode. PAUSE light turns OFF.
Adjusting the Position of the Top of the Label
This procedure positions the printing on the label relative to the top
edge of the label.
1. Press the MODE twice briefly then press and hold for about five sec-
onds until the lights change. PAUSE and DARKEN and CALIBRATE
lights turn ON.
2. Press UP or DOWN to adjust the current setting.
3. Press the MODE key twice briefly. The MODE lights will flash ON
and OFF to indicate that the settings have been saved in memory.
4. Press PAUSE to exit PAUSE mode. PAUSE light turns OFF.
4-6 Zebra S-Series User’s Guide
58