Filter
Top Products
Fanfold Supply Bin
Your printer may be equipped with an optional internal Fanfold Supply
Bin. It is used to load fanfold media within the media compartment,
and it protects the media from environmental contaminants such as dust
and dirt.
The Fanfold Media Supply Bin is fully adjustable. It accommodates
media from 1.57" (40 mm) to 3.54" (90 mm) wide (7.17" [183 mm]
wide for the 160S) and 3.5" (89 mm) to 8" (203mm) long. The maxi-
mum stack height for 8" long media is 4.5". Stack heights of 6.5" may
be achieved with media less than 3.5" long.
The Fanfold Supply Bin may be installed in the field by the operator.
To install the Fanfold Supply Bin, follow the instructions included
with the option.
Note: The Fanfold Supply Bin, Peel-Off Option, and Rewind Option
are mutually exclusive. The Fanfold Supply Bin may not be
installed in S-Series Printers with the Peel-Off Option or the
Rewind Option. Fanfold media may be used with the Rewind
Spindle installed by using one of the external Fanfold supply
access slots (at the bottom and rear of the printer).
External ZebraNet™ (Ethernet) Interface
Allows you to connect your printer to your ethernet network. Available
for both 10Base-2 and 10Base-T networks.
Black Mark (Reflective) Sensor (105Se Only)
Utilizes continuous media with black marks printed on the back of the
label liner. The Black Mark Sensor determines the label length and the
top of the label by detecting the black mark (similar to the way a Trans-
missive Sensor detects the gap or notch).
This option is in addition to the standard transmissive sensor and is soft-
ware- or switch-selectable.
9-2 Zebra S-Series User’s Guide
82