Zebra Technologies 105Se Printer User Manual


 
Upper Transmissive Media Sensor Position Adjustment
To adjust the upper media sensor, refer to Figure 7.2 and follow these
steps.
1. Remove the ribbon and locate the Upper Media Sensor.
2. Loosen the Phillips head screw.
3. Slide the upper sensor along the slot to the desired position. When using
media that has a web between labels, position the media sensor anywhere
along the web (except if you have labels with rounded corners, do not posi-
tion the sensor where the rounded corners of the label might be detected).
When using tag stock, position the upper sensor directly over the hole or
notch.
4. Tighten the Phillips head screw.
Note: To adjust the upper section of the Transmissive Media Sensor
for the outside half of the media width, call a service
technician.
Zebra S-Series User’s Guide 7-3
Figure 7.2 Upper Media Sensor (105Se shown)
71