Filter
Top Products
9. Reinsert the switch into the system and power up.
10. Use a terminal emulation program to access the switch console.
Fabric Interface Out of Band Ethernet Connection
Connect an Ethernet cable from the Ethernet Switch Blade front panel MGMT OOB (4 in Figure
10.3) to your PC.
1. Configure a host on the 10.0.0.0 network.
2. The OpenArchitect switch is preconfigured with address 10.0.0.42. telnet to 10.0.0.42.
telnet 10.0.0.42
3. After you are connected, enter the login name root. No password is required.
OpenArchitect login: root
4. You are now logged in and should see the following shell prompt:
[Ethernet Switch Blade-OA3.2.2h]#
NOTE: The OOB port is not active by default with the factory configured configuration.
The first time you log into the switch, either in-band or through the console cable, you must
use the ifconfig command to make the port active.
Ethernet Switch Blade User's Guide release 3.2.2j page 149