Filter
Top Products
zspconfig
NAME
zspconfig - configure and start surviving partner
SYNOPSIS
zspconfig [-d <level>] [-p <directory_path>] [-u
<dhcp_interface>] [-c <dhclient.conf>] [-t <timeout>] [-s]
[-v] -f <file>
DESCRIPTION
zspconfig is used to configure and start the Surviving Partner software. With the -f option a
configuration file is provided that completely describes the network setup and desired behavior of
all of the switches participating in the Surviving Partner. With the -u option the interface on
which to run dhclient to retrieve a configuration file must be provided. The configuration file
format retrieved by a -u is identical to that supplied with -f. It is envisioned that the -f option
is used for initial configuration, and all subordinate and replacement switches run zspconfig
with the -u option. The -v option prints the current version of zspconfig and performs no
actions.
OPTIONS
-d <level> Set the debug level. The default debug level is 1.
The higher the level, the more debugging output is produced.
Debugging output is sent to the console.
-p <directory_path>
Set the directory path for where zspconfig places the scripts
it generates. The default location is
/etc/rcZ.d/surviving_partner.
-u < dhcp_interface>
Come up as an unconfigured slave. Use the specified
<dhcp_interface> to retrieve the configuration. User
confirmation is not required unless the –s option is also
used.
-c <dhclient.conf>
Use file <dhclient.conf> as the configuration file to dhclient
when retrieving configuration information. If –c is not used,
a default configuration file is created and used. Only valid
with the –u option.
-t <timeout> Time to wait in seconds before giving up on
Ethernet Switch Blade User's Guide release 3.2.2j page 328