Filter
Top Products
Default Fabric Interface Configuration
Editing the S50layer2 script can change the Ethernet Switch Blade Fabric Interface default
configuration. The S50Layer2 script and included example scripts
(/etc/rcZ.d/examples) can be used as templates to create custom scripts. The default
S50layer2 script configures the switch accordingly:
1. S20stack - Script that calls zstack to combine the two BCM56504 24-port switch fabric
chips into a single 48 port virtual switch. zstack must be run before any other switch
configuration. (Editing this script is not recommended.)
2. S50layer2 - Script that sets up a basic Layer 2 switch. All 48 ports are set up on one VLAN.
This configuration script is appropriate for an Ethernet Switch Blade. It may need to be modified
for other models.
Ethernet Switch Blade User's Guide release 3.2.2j page 163
OpenArchitect login: root
sh-2.04# ifconfig
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
UP LOOPBACK RUNNING MTU:16144 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
zhp0 Link encap:Ethernet HWaddr 00:11:65:09:E0:18
inet addr:10.0.0.42 Bcast:10.0.0.255 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:281 errors:0 dropped:0 overruns:0 frame:0
TX packets:29 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:100
RX bytes:30018 (29.3 Kb) TX bytes:2027 (1.9 Kb)
Base address:0xc000
sh-2.04#