Filter
Top Products
Prestige 2602H/HW Series User’s Guide
224 Chapter 17 VPN Screens
IP Address Start When the Local Address Type field is configured to Single, enter a (static) IP
address on the LAN behind your Prestige. When the Local Address Type field is
configured to Range, enter the beginning (static) IP address, in a range of
computers on your LAN behind your Prestige. When the Local Address Type
field is configured to Subnet, this is a (static) IP address on the LAN behind your
Prestige.
End / Subnet Mask When the Local Address Type field is configured to Single, this field is N/A.
When the Local Address Type field is configured to Range, enter the end (static)
IP address, in a range of computers on the LAN behind your Prestige. When the
Local Address Type field is configured to Subnet, this is a subnet mask on the
LAN behind your Prestige.
Remote Remote IP addresses must be static and correspond to the remote IPSec router's
configured local IP addresses. The remote fields do not apply when the Secure
Gateway IP Address field is configured to 0.0.0.0. In this case only the remote
IPSec router can initiate the VPN.
Two active SAs cannot have the local and remote IP address(es) both the same.
Two active SAs can have the same local or remote IP address, but not both. You
can configure multiple SAs between the same local and remote IP addresses, as
long as only one is active at any time.
Remote Address
Type
Use the drop-down menu to choose Single, Range, or Subnet. Select Single
with a single IP address. Select Range for a specific range of IP addresses.
Select Subnet to specify IP addresses on a network by their subnet mask.
IP Address Start When the Remote Address Type field is configured to Single, enter a (static) IP
address on the network behind the remote IPSec router. When the Remote
Address Type field is configured to Range, enter the beginning (static) IP
address, in a range of computers on the network behind the remote IPSec router.
When the Remote Address Type field is configured to Subnet, enter a (static) IP
address on the network behind the remote IPSec router.
End / Subnet Mask When the Remote Address Type field is configured to Single, this field is N/A.
When the Remote Address Type field is configured to Range, enter the end
(static) IP address, in a range of computers on the network behind the remote
IPSec router. When the Remote Address Type field is configured to Subnet,
enter a subnet mask on the network behind the remote IPSec router.
Address
Information
Local ID Type Select IP to identify this Prestige by its IP address.
Select DNS to identify this Prestige by a domain name.
Select E-mail to identify this Prestige by an e-mail address.
Content When you select IP in the Local ID Type field, type the IP address of your
computer in the local Content field. The Prestige automatically uses the IP
address in the My IP Address field (refer to the My IP Address field description)
if you configure the local Content field to 0.0.0.0 or leave it blank.
It is recommended that you type an IP address other than 0.0.0.0 in the local
Content field or use the DNS or E-mail ID type in the following situations.
When there is a NAT router between the two IPSec routers.
When you want the remote IPSec router to be able to distinguish between VPN
connection requests that come in from IPSec routers with dynamic WAN IP
addresses.
When you select DNS or E-mail in the Local ID Type field, type a domain name
or e-mail address by which to identify this Prestige in the local Content field. Use
up to 31 ASCII characters including spaces, although trailing spaces are
truncated. The domain name or e-mail address is for identification purposes only
and can be any string.
Table 72 VPN IKE (continued)
LABEL DESCRIPTION