Filter
Top Products
Prestige 2602H/HW Series User’s Guide
Chapter 39 System Maintenance 401
CHAPTER 39
System Maintenance
This chapter leads you through SMT menus 24.8 to 24.10.
39.1 Command Interpreter Mode
The Command Interpreter (CI) is a part of the main system firmware. The CI provides much of
the same functionality as the SMT, while adding some low-level setup and diagnostic
functions. Enter the CI from the SMT by selecting menu 24.8. See the included disk or the
zyxel.com web site for more detailed information on CI commands. Enter 8 from Menu 24 —
System Maintenance. A list of valid commands can be found by typing help or ? at the
command prompt. Type “
exit” to return to the SMT main menu when finished.
Figure 241 Command Mode in Menu 24
Figure 242 Valid Commands
Menu 24 - System Maintenance
1. System Status
2. System Information and Console Port Speed
3. Log and Trace
4. Diagnostic
5. Backup Configuration
6. Restore Configuration
7. Upload Firmware
8. Command Interpreter Mode
9. Call Control
10. Time and Date Setting
11. Remote Management
Enter Menu Selection Number:
Copyright (c) 1994 - 2005 ZyXEL Communications Corp.
ras> ?
Valid commands are:
sys exit device ether
wan poe config wlan
ip ipsec ppp bridge
hdap lan radius 8021x
dsp voice