Filter
Top Products
Prestige 2602H/HW Series User’s Guide
Chapter 43 VPN/IPSec Setup 427
Figure 263 Menu 27.1.1 IPSec Setup
The following table describes the fields in this menu.
Menu 27.1.1 – IPSec Setup
Index= 1 Name= Taiwan
Active= Yes Keep Alive= No Nat Traversal= No
Local ID type= IP Content:
My IP Addr= 0.0.0.0
Peer ID type= IP Content:
Secure Gateway Address= zw50test.zyxel.com.tw
Protocol= 0 DNS Server= 0.0.0.0
Local: Addr Type= SINGLE
IP Addr Start= 1.1.1.1 End/Subnet Mask= N/A
Port Start= 0 End= N/A
Remote: Addr Type= SUBNET
IP Addr Start= 4.4.4.4 End/Subnet Mask= 255.255.0.0
Port Start= 0 End= N/A
Enable Replay Detection = No
Key Management= IKE
Edit Key Management Setup= No
Press ENTER to Confirm or ESC to Cancel:
Table 148 Menu 27.1.1 IPSec Setup
FIELD DESCRIPTION
Index This is the VPN rule index number you selected in the previous menu.
Name Enter a unique identification name for this VPN rule. The name may be up to 32
characters long but only 10 characters will be displayed in Menu 27.1 - IPSec
Summary.
Active Press [SPACE BAR] to choose either Yes or No. Choose Yes and press [ENTER] to
activate the VPN tunnel. This field determines whether a VPN rule is applied before a
packet leaves the firewall.
Keep Alive Press [SPACE BAR] to choose either Yes or No. Choose Yes and press [ENTER] to
have the Prestige automatically re-initiate the SA after the SA lifetime times out, even
if there is no traffic. The remote IPSec router must also have keep alive enabled in
order for this feature to work.