ZyXEL Communications 50 Network Card User Manual


 
ZyWALL 50 Internet Security Gateway
Initial Setup 3-1
Chapter 3
Initial Setup
This chapter explains how to perform initial ZyWALL setup and gives an overview of SMT menus.
3.1 Turning On Your ZyWALL
At this point, you should have connected the console port, the LAN port, the WAN port and the power port
to the appropriate devices or lines. Plug the power adapter into a wall outlet. The PWR LED should turn on.
The SYS LED will turn on after the system tests are complete. The WAN LED and one of the LAN LEDs
should turn on immediately after the SYS LED turns on, if connections have been made to the LAN and
WAN ports.
3.1.1 Initial Screen
When you turn on your ZyWALL, it performs several internal tests as well as line initialization.
After the tests, the ZyWALL asks you to press
[ENTER] to continue, as shown next.
Figure 3-1 Initial Screen
3.1.2 Entering the Password
The login screen appears after you press [ENTER], prompting you to enter the password, as shown below.
For your first login, enter the default password “1234”. As you type the password, the screen displays an
(X) for each character you type.
Please note that if there is no activity for longer than five minutes after you log in, your ZyWALL will
automatically log you out and will display a blank screen. If you see a blank screen, press [ENTER] to
bring up the login screen again.
Copyright (c) 1994 - 2001 ZyXEL Communications Corp.
initialize ch =0, ethernet address: 00:a0:c5:41:51:61
initialize ch =1, ethernet address: 00:a0:c5:41:51:62
Press ENTER to continue...