Filter
Top Products
ZyWALL 50 Internet Security Gateway
Remote Node Setup 4-7
4.2 Editing TCP/IP Options (with Ethernet Encapsulation)
Move the cursor to the Edit IP field in menu 11.1, press [SPACE BAR] to select Yes. Press [ENTER] to
open Menu 11.3 - Network Layer Options.
Figure 4-4 Menu 11.3 — Remote Node Network Layer Options
The next table gives you instructions about configuring remote node network layer options.
Table 4-4 Remote Node Network Layer Options Menu Fields
FIELD DESCRIPTION EXAMPLE
IP Address
Assignment
If your ISP did not assign you an explicit IP address, select Dynamic;
otherwise select Static and enter the IP address & subnet mask in the
following fields.
Dynamic
IP Address If you have a Static IP Assignment, enter the IP address assigned to you
by your ISP.
IP Subnet
Mask
If you have a Static IP Assignment, enter the subnet mask assigned to
you.
Gateway IP
Addr
If you have a Static IP Assignment, enter the gateway IP address
assigned to you.
Network
Address
Translation
Use [SPACE BAR] to select either Full Feature, None or SUA Only. See
the NAT chapter for a full discussion on this feature.
SUA Only
Metric This field is valid only for PPTP/PPPoE encapsulation. The metric
re
p
resents the “cost” of transmission for routin
g
p
ur
p
oses. IP routin
g
3
Menu 11.3 - Remote Node Network Layer Options
IP Address Assignment= Dynamic
IP Address= N/A
IP Subnet Mask= N/A
Gateway IP Addr= N/A
Network Address Translation= SUA Only
Metric= N/A
Private= N/A
RIP Direction= None
Version= N/A
Multicast= None
Enter here to CONFIRM or ESC to CANCEL:
Press Space Bar to Toggle