Filter
Top Products
ZyWALL 50 Internet Security Gateway
5-8 LAN Setup
Figure 5-7 Menu 3.2.1 — IP Alias Setup
Use the instructions in the following table to configure IP Alias parameters.
Table 5-5 IP Alias Setup Menu Fields
FIELD DESCRIPTION EXAMPLE
IP Alias
Choose Yes to configure the LAN network for the ZyWALL. Yes
IP Address Enter the IP address of your ZyWALL in dotted decimal notation. 192.168.2.1
IP Subnet Mask Your ZyWALL will automatically calculate the subnet mask based on
the IP address that you assign. Unless you are implementing
subnetting, use the subnet mask computed by the ZyWALL.
255.255.255.0
RIP Direction Press [SPACE BAR] to select the RIP direction. Options are:
Both, In Only, Out Only or None.
None
Version Press [SPACE BAR] to select the RIP version. Options are:
RIP-1, RIP-2B or RIP-2M.
RIP-1
Incoming
Protocol Filters
Enter the filter set(s) you wish to apply to the incoming traffic
between this node and the ZyWALL.
1
Outgoing
Protocol Filters
Enter the filter set(s) you wish to apply to the outgoing traffic between
this node and the ZyWALL.
2
When you have completed this menu, press [ENTER] at the prompt [Press ENTER to Confirm…] to save
your configuration, or press [ESC] at any time to cancel.
Menu 3.2.1 - IP Alias Setup
IP Alias 1= No
IP Address= N/A
IP Subnet Mask= N/A
RIP Direction= N/A
Version= N/A
Incoming protocol filters= N/A
Outgoing protocol filters= N/A
IP Alias 2= No
IP Address= N/A
IP Subnet Mask= N/A
RIP Direction= N/A
Version= N/A
Incoming protocol filters= N/A
Outgoing protocol filters= N/A
Enter here to CONFIRM or ESC to CANCEL:
Press Space Bar to Toggle.