Filter
Top Products
ZyWALL 50 Internet Security Gateway
4-4 General and WAN Setup
Figure 4-2 Menu 2 — WAN Setup
The MAC address field allows users to configure the WAN port's MAC address by using either the factory
default or cloning the MAC address from a computer on your LAN. Once it is successfully configured, the
address will be copied to the rom file (ZyNOS configuration file). It will not change unless you change the
setting in menu 2 or upload a different rom file.
The following table contains instructions on how to configure your WAN setup.
Table 4-2 WAN Setup Menu Fields
FIELD DESCRIPTION EXAMPLE
MAC Address
Assigned By Press [SPACE BAR] to choose one of two methods to assign a MAC
Address. Choose Factory Default to select the factory assigned
default MAC Address. Choose IP Address attached on LAN to use
the MAC Address of that computer whose IP you give in the following
field.
Factory
default
IP Address
This field is applicable only if you choose the IP Address attached
on LAN method. Enter the IP address of the computer on the LAN
whose MAC you are cloning.
N/A
When you have completed this menu, press [ENTER] at the prompt “Press ENTER to Confirm…” to save
your configuration, or press [ESC] at any time to cancel.
Menu 2 - WAN Setup
MAC Address:
Assigned By= Factory default
IP Address= N/A
Press ENTER to Confirm or ESC to Cancel:
Press Space Bar to Toggle