A SERVICE OF

logo

Open as PDF
next previous
Interface Access and System Information
Interface Access: Console/Serial Link, Web, and Inbound Telnet
The switch implements the Event Log change immediately. The switch implements
the other console changes after executing
write memory and reload.
Figure 7-4. Example of Executing the Console Command with Multiple Parameters
Note When using redundant management, console settings, such as mode, flow-
control and baud-rate, are the same on both management modules. There
cannot be individual settings for each management module.
You can also execute a series of console commands and then save the
configuration and boot the switch. For example:
Configure
the
individual
parameters.
Save the
changes.
Boot the
switch.
Figure 7-5. Example of Executing a Series of Console Commands
7-10