Redundancy (Switches 8200zl)
Displaying Management Information
The currently active module remains active on boot (assuming no selftest
failure) unless you make the newly inserted management module active using
this command:
ProCurve(config)# redundancy active-management
standby
The standby management module becomes the active management module.
Displaying Management Information
Active Management Module Commands
Show Modules
The show modules command displays information about all the modules in the
switch as well as additional component information for the following:
■ System Support Modules (SSM)—identification, including serial
number
■ Mini-GBICS—a list of installed mini-GBICs displaying the type, “J”
number, and serial number (when available)
Syntax: show modules [details]
Displays information about the installed modules, including:
• The slot in which the module is installed
• The module description
• The serial number
• The System Support Module description, serial number,
and status (8200zl switches only)
Additionally, the part number (J number) and serial number
of the chassis is displayed.
15-23
