2-28 Intel® Server RAID Controller U3-1 User’s Manual Rev 1.0
Advanced Installation Steps
c. After the NT installation is complete, install the following components and software:
— Microsoft Windows NT 4.0 Service Pack 5 or greater
— Microsoft Internet Explorer 4.00 or greater
5. If your browser uses a proxy server, then configure your browser using the procedure in
Section B.6, “Browser Configuration During Initial Installation” on page B-5 andreturntothis
procedure. If you have not configured your browser to use a proxy server, then go to step 6.
6. Install the SRCU31 software (run the SRCU31 setup).
Note: You must have administrative level permissions to install SRCU31 software. This
procedure assumes that the SRCU31 hardware and Windows NT server are installed and
operational in your system.
a. Insert the SRCU31 CD-ROM in the CD-ROM drive. If the Software Installation Main
Menu does not appear, then run the setup.exe file that resides at:
<CD-ROM root>\os_setup\winnt\setup.exe on the CD-ROM.
b. ClickontheSetup button. See Figure 2-20. Follow the on-screen prompts to complete
installation.
The three components in the window in Figure 2-21 are preselected. Add the remote
storage console component by clicking on the remote storage console box.
Note: The DMI and SNMP components are not selected by default. Refer to section
Section 4.2, Intel® Integrated RAID Software Component Installation for information on
DMI and SNMP installation.
A progress bar appears that measures the progress of the SRCU31 setup. When this screen
completes, you have completed the SRCU31 setup.
Note: Refer to section “Intel® Integrated RAID Software Component Installation” on
page 4-3 of the “Using the Storage Console” chapter for information on HP Openview
and RAID Monitor.
7. See Chapter 4, Section 4.3, “Configuring RAID Volumes Using the Intel® Integrated RAID
StorageConsole”onpage4-12to customize your RAID volumes using Storage Console.
