2-32 Intel® Server RAID Controller U3-1 User’s Manual Rev 1.0
Advanced Installation Steps
2.5.4 Setup and Installation for Microsoft Windows NT* Server
4.0
2.5.4.1 In this Section
• RAID Requirements for Microsoft Windows NT Server 4.0
• Installing Microsoft Windows NT Server 4.0 on a Intel® Integrated RAID Volume
• Installing Microsoft Windows NT Server 4.0 on a Pass-through Disk or another Storage
Device
• Install Intel Server RAID Controller U3-1 on an Existing NT 4.0 Server
2.5.4.2 RAID Requirements for Microsoft Windows NT Server 4.0
Note: This document, when referring to NT Server 4.0, also applies to the following Windows NT 4.0
Server subtypes:
• Microsoft Windows NT Server 4.0 Enterprise Edition
When installing the SRCU31 kit for Microsoft Windows NT Server, note the following system
requirements.
Have all required system hardware and software components available before proceeding with the
setup and installation.
RAID Hardware Requirements
• Server with CD-ROM Drive not attached to Intel® Server RAID Controller U3-1
• One available PCI slot (64bit, 33MHz recommended)
• Monitor display resolution of 800 x 600 or higher (recommended)
• Intel® Server RAID Controller U3-1 Adapter Card
• PCI 2.2 Compliant System BIOS
• Memory: 3.3v, 168-pin gold-plated, unbuffered PC100, ECC, SDRAM single or double row,
DIMM modules that are of 32MB, 64MB, 128MB capacities (see supported parts at http://
support.intel.com/support/motherboards/server/srcu31)
RAID Software Requirements
• SRCU31 CD-ROM
• Hard Disk Space: 9 MB Minimum
• Windows NT Installation Diskette (Microsoft Windows NT SCSI Miniport Diskette). See
Chapter 3, “Exploring the Utilities” to create this diskette.
• Microsoft Windows NT Server 4.0
†
• Microsoft Windows NT 4.0 Service Pack 5 or greater
†
• Microsoft Internet Explorer 4.0 or greater or Netscape 4.08 or greater
†
