2-62 Intel® Server RAID Controller U3-1 User’s Manual Rev 1.0
Advanced Installation Steps
2.5.9 Setup and Installation for UnixWare*
2.5.9.1 In this Section
•
RAID Requirements for UnixWare
• Installing UnixWare on a RAID Volume
• Installing UnixWare on a Pass-through Device or another Storage Device
• Install Intel® Server RAID Controller U3-1 on an Existing UnixWare Server
• Uninstalling Intel® Server RAID Controller U3-1 from UnixWare
2.5.9.2 RAID Requirements for UnixWare
When installing SRCU31 for UnixWare 7.1, note the following system requirements.
RAID Hardware Requirements
• Server with CD-ROM Drive not attached to Intel® Server RAID Controller U3-1
• One available PCI slot (64bit, 33MHz recommended)
• Monitor display resolution of 800 x 600 or higher (recommended)
• Intel® Server RAID Controller U3-1 Adapter Card
• PCI 2.2 Compliant System BIOS
• Memory: 3.3v, 168-pin gold-plated, unbuffered PC100, ECC, SDRAM single or double row,
DIMM modules that are of 32MB, 64MB, 128MB capacities (see supported parts at http://
support.intel.com/support/motherboards/server/srcu31)
RAID Software Requirements
• SRCU31 CD-ROM
• Hard disk space: minimum 20 MB
• UnixWare Installation Diskette (to create this diskette, see Chapter 3, “Exploring the
Utilities”)
• SCO UnixWare 7.1 software with Netscape 4.08 or greater (included with SCO)
†
†
NotsuppliedwithSRCU31.
Have all required system hardware and software components available before proceeding with the
setup and installation.
Warning: Do not install OSM(s) downloaded from OS vendor websites. The OSMs provided on the Intel
Server RAID Controller U3-1 CD-ROM are a later version than the OSMs currently provided by
OS vendors. Using OSMs other than those provided on the SRCU31 CD-ROM may cause
unpredictable results.
