Filter
Top Products
2
INSTALLING THE SYSTEM
This chapter describes how to install your
SuperStack
®
II Switch 3900 on a table top, in a
free-standing stack with other SuperStack II products,
or in a distribution rack.
See Appendix B for site requirements.
■ To install the Switch 3900 system on a table top or
in a free-standing stack, read these sections:
■ “Before You Begin” (the next section)
■ “Installing the System on a Table Top or in a
Free-Standing Stack” on page 2-2
■ To install the Switch 3900 system in a distribution
rack, read these sections:
■ “Before You Begin” (the next section)
■ “Installing the System in a Distribution Rack” on
page 2-3
Before You Begin
Before you begin this procedure, be sure to:
■ Move the Switch 3900 system close to where you
plan to install it.
Install the system near an easily accessible power
outlet. You can power down the system only by
removing the power cord from the power source.
■ Have a No. 1 Phillips screwdriver available.
■ Have the system mounting kit available. See
Table 2-1.
Table 2-1 Switch 3900 System Mounting Kit
Qty Item To use in
4 Rubber feet
(self-adhesive)
Stacking the system on a
table or in a stack
2 Mounting brackets Installing the system in a
distribution rack
6 M4 x 10 pan-head
screws
Installing the distribution rack
brackets