3Com 3CRWEASY96A Network Router User Manual


 
10
2
I
NSTALLING
THE
O
UTDOOR
B
RIDGE
This equipment must be installed in compliance with local and national building
codes, regulatory restrictions, and FCC rules. For the safety of people and
equipment, only professional network personnel should install the bridge, cables,
and antennas.
I
NSTALLATION
R
EQUIREMENTS
The following items are required for installation:
For a point-to point configuration, two 3Com outdoor bridges.
For a point-to-multipoint configuration, one 3Com 11Mbps Wireless LAN
Access Point 8000 (or other Wi-Fi compliant access point) with an
omnidirectional antenna for one building, and one 3Com outdoor bridge for
each other building.
Mounting hardware (supplied with each bridge).
Properly grounded outdoor mast or wall mount.
Lightning arrestor properly grounded at each building in the topology.
Outdoor rated category 5 Ethernet cable (3Com part number
3CWE487 recommended).
P
OWER
R
EQUIREMENTS
The bridge complies with the IEEE 802.3af power-over-Ethernet standard. It
receives power over outdoor rated Ethernet cable (3Com part number 3CWE487
recommended). Installation requires the use of either the 3Com power supply
provided or IEEE 802.3af compliant power supply equipment (output power rated
48 V dc @ 200 mA minimum). Such equipment must b
e
safety certified according
to UL, CSA, IEC or other applicable national or international safety requirements
CAUTION
: Before installing, see the important warnings and cautions in “Safety
Information” on page 13.