Filter
Top Products
Using SNMP
53
Displaying SNMP
Settings
To display the SNMP settings configured on the switch, enter the
following command:
show management
This command displays the following information:
■
Enable/disable state for Telnet, SNMP, and Web access
■
SNMP community strings
■
Authorized SNMP station list
■
SNMP trap receiver list
■
RMON polling configuration
config snmp access-profile [readonly |
readwrite] {<access_profile> | none}
Applies an access profile for SNMP access.
You can create different access profiles for
readonly and readwrite access to the switch.
The
none
option removes any previously
configured access profile assignment.
config snmp add trapreceiver
<ipaddress> community <string>
Adds the IP address of a specified trap
receiver. The IP address can be a unicast,
multicast, or broadcast. A maximum of six
trap receivers is allowed.
config snmp community [readonly |
readwrite] <string>
Adds an SNMP read or read/write community
string. The default
readonly
community
string is
public
. The default
readwrite
community string is
private
. Each
community string can have a maximum of
126 characters, and can be enclosed by
double quotation marks.
config snmp delete trapreceiver
[<ip_address> community <string> | all]
Deletes the IP address of a specified trap
receiver or all authorized trap receivers.
config snmp syscontact <string>
Configures the name of the system contact.
A maximum of 255 characters is allowed.
config snmp sysname <string>
Configures the name of the switch. A
maximum of 32 characters is allowed. The
default sysname is the model name of the
device (for example,
3C17705)
. The
sysname
appears in the switch prompt.
config snmp syslocation <string>
Configures the location of the switch. A
maximum of 255 characters is allowed.
Table 13
SNMP Configuration Commands (continued)
Command Description