Filter
Top Products
Chapter 2: Installing the monitor
29
The locations for attaching the security screws are shown in Figure 13 on
page 38.
Mounting the ET 350 monitor with Moisture Deflector
The ET 350 monitor with Moisture Deflector comes with four sealing
screws fastened to the back of the unit. 3M Touch Systems recommends
that if you need to remove the sealing screws to access the enclosure, you
re-attach the screws after closing the enclosure.
The ET 350 monitor with Moisture Deflector must be mounted
vertically—with no more than 10 degrees variance from vertical—for the
Moisture Deflector to operate. As long as the 10 degree rule is observed, it
is possible to mount the monitor with the Moisture Deflector using any of
the mounting kits described above.
Important
If security screws are used, the operator will not be able to access the enclosure
without a security screwdriver. This means that the operator may be unable to
perform such tasks as changing display settings.