Filter
Top Products
50
2.2.5.7 show startup-config
Command: show startup-config
Function: Display the switch parameter configurations written into the Flash memory at
the current operation, those are usually also the configuration files used for the next
power-up.
Default: If the configuration parameters read from the Flash are the same as the default
operating parameter, nothing will be displayed.
Command mode: Admin Mode
Usage Guide: The show running-config command differs from show startup-config in
that when the user finishes a set of configurations, show running-config displays the
added-on configurations whilst show startup-config won’t display any configurations.
However, if write command is executed to save the active configuration to the Flash
memory, the displays of show running-config and show startup-config will be the
same.
2.2.5.8 show interfaces switchport
Command: show interfaces switchport [ethernet <interface >]
Function: Display VLAN interface mode and VLAN number, and Trunk port information
for the switch.
Parameter: <interface > is the port number, which can be any port information exist in the
switch.
Command mode: Admin Mode
Example: Display the VLAN information for interface ethernet 1/1.
Switch#show interfaces swichport ethernet 1/1
Ethernet1/1
Type : Universal
Mac addr num : -1
Mode : Access
Port VID : 1
Trunk allowed Vlan : ALL
Displayed information Description
Ethernet1/1 Corresponding Ethernet interface number;
Type Current Interface Type
Mac addr num MAC address number can be learn by the current
interface
Mode : Access VLAN mode of the current Interface