Filter
Top Products
Heuristic Power Management
Chapter 2 Operating on Battery Power 41
There is one necessary condition for the computer to enter
Standby mode:
❑
Heuristic Power Management must be set to [ENABLED].
There are four ways to enter Standby mode:
❑
Pressing the Standby hot key Fn-F3
❑
If the waiting time determined by the computer’s HPM
unit elapses without any system activity
❑
Closing the display cover
❑
When the computer is about to enter Hibernation mode
(e.g., during a battery low condition), but the
Hibernation file is invalid or not present
The following signals indicate that the computer is in
Standby mode:
❑
The buzzer beeps
❑
The Standby indicator lights
To leave Standby mode and return to normal mode:
❑
Press any key
❑
Move the active pointing device (internal or external, PS/
2 or serial)
❑
Have the Resume Timer set and let it be matched
❑
Open the display cover
Note: If the computer beeps but does not enter Standby
mode after pressing the Standby hot key, it means the
operating system will not allow the computer to enter the
power-saving mode.
Warning: Unstored data is lost when you turn off the
computer power in Standby mode or when the
battery is drained.
700-e.book : 700-2e.fm Page 41 Tuesday, July 28, 1998 10:24 AM