Filter
Top Products
3 System upgrade
76
3 Install the memory board. For instructions, see “Hot-insertion of a
Memory Board” on page 54 or “Cold Insertion of a Memory
Board”on page 71, depending on your server configuration.
4 Observe the post-installation instructions described on page 34.
To reconfigure the system memory:
The system automatically detects the amount of memory installed. Run
the BIOS setup to view the new value for total system memory and
make a note of it.
PCI card
PCI cards installed in slots 1 to 5 are hot-pluggable. If you are adding or
removing a card from one of these slots, you can do so without
powering down the server.
Removing a non-hot-plug PCI card
Caution! Damage to the system occurs if power is not removed
from the system prior to removal or installation of non-hot-plug
boards.
1 Observe the ESD precautions and pre-installation instructions
described on page 33.
2 Disconnect any cables attached to the PCI card.
3 Perform steps 5 to 9 described in the “To remove a hot-plug PCI
card with OS hot-plug interface:” on page 55.
Installing a non-hot-plug PCI card
1 Observe the ESD precautions and pre-installation instructions
described on page 33.
2 Perform steps 3 to 10 described in the “Installing a hot-plug PCI
card” on page 56.
3 Observe the post-installation instructions described on page 34.