Filter
Top Products
Machine Maintenance 3-17
Removing the DC-In Module (WLAN Board) 0
NOTE:
NOTE:
For models that have M-SATA board installed, please proceed to page 3-18, “Removing
the DC-In Module (M-SATA Board)”
1. Perform the “Removing the Lower Case” procedure described on page 3-9.
2. Perform the “Removing the Battery Pack” procedure described on page 3-10.
3. Disconnect the DC-In cable from the WLAN board (1) then release the DC-In cable from
the self adhesive tape securing it (2).
Figure 3-18. DC-In Cable (WLAN Board)
4. Detach the DC-In socket from the upper case.
Figure 3-19. DC-In