Filter
Top Products
Machine Maintenance 3-35
Removing the M-SATA Board 0
1. Perform the “Removing the Lower Case” procedure described on page 3-9.
2. Perform the “Removing the Battery Pack” procedure described on page 3-10.
3. Perform the “Removing the WLAN Module” procedure described on page 3-15.
4. Release the connector latches (1) from the M-SATA board, then disconnect the WLAN &
mini 1 cables (2).
Figure 3-52. WLAN & Mini 1 Cables
5. Detach the M-SATA board from the upper case.
Figure 3-53. M-SATA Board
NOTE:
NOTE:
A circuit board that is > 10cm
2
has been highlighted with a yellow rectangle in
Figure 3-53. Follow the local regulations for disposing this type of circuit board.