Filter
Top Products
3-38 Machine Maintenance
Removing the Power Button Board 0
1. Perform the “Removing the Lower Case” procedure described on page 3-9.
2. Perform the “Removing the Battery Pack” procedure described on page 3-10.
3. Release the latch (1) from the mainboard then disconnect the power button cable (2).
Figure 3-58. Power Button Cable
4. Release the power button board from the adhesive tape securing it (1) then tilt the power
button board (2) and detach it from the upper case.
Figure 3-59. Power Button Board Adhesive Tape
NOTE:
NOTE:
A circuit board that is > 10cm
2
has been highlighted with a yellow rectangle in
Figure 3-59. Follow the local regulations for disposing this type of circuit board.