Filter
Top Products
3-34 Machine Maintenance
Removing the WLAN Board 0
NOTE:
NOTE:
For models that have M-SATA board installed, please proceed to page 3-35, “Removing
the M-SATA Board”.
1. Perform the “Removing the Lower Case” procedure described on page 3-9.
2. Perform the “Removing the Battery Pack” procedure described on page 3-10.
3. Perform the “Removing the WLAN Module” procedure described on page 3-15.
4. Release the connector latches (1) from the WLAN board, then disconnect the WLAN &
mini 1 cables (2). Disconnect the power cable from the WLAN board (3).
Figure 3-50. WLAN, Mini 1 & Power Cables
5. Detach the WLAN board from the upper case.
Figure 3-51. WLAN Board
NOTE:
NOTE:
A circuit board that is > 10cm
2
has been highlighted with a yellow rectangle in
Figure 3-51. Follow the local regulations for disposing this type of circuit board.