Filter
Top Products
5-10
ANA-5910/5930/5940 User’s Guide
ANA-5910/5930/5940 User’s Guide
Stock Number: 510694-00, Rev. C Page: 5-10
Print Spec Number: 493081-00
Current Date: 5/28/97 ECN Date: 05/29/97
Set the parameters in the dialog box as follows, and select OK:
8
Remove the RFC 1577 CIP ARP Server diskette from the
diskette drive.
9
Select Close to exit the Network Settings dialog box.
10
Select Yes to save and initialize changes.
Determining the CIP ARP Server Address
Note:
Enter commands such as
aatmcnfg
should be entered
from the MS-DOS command prompt, which you can access
by selecting the MS-DOS Command Prompt icon in
Program Manager’s Main group window.
To obtain the 20-byte, ATM ARP server address
Note:
The ATM driver should be started and registered to
the switch.
1
On the ARP server, enter the following command from the
directory (
\etc\opt\adptaatm\bin
) where the ATM CIP software
was installed:
aatmcnfg -p
The ATM address for the ARP server appears, for example,
39.11.22.11.22.11.22.00.00.11.22.11.22.00.00.d1.00.04.45.00
Parameter Setting
IP Address Enter the logical IP subnet where this
ATM ARP server resides; 15
characters maximum; 4 bytes, dotted
decimal format; for example,
192.9.200.0
Subnet Mask Enter the IP subnetwork mask for the
ATM adapter; 15 characters
maximum; 4 bytes, dotted decimal
format; for example, 255.255.255.0
Autostart ARP Server Select the check box to automatically
start the ARP server driver at boot-up.