ADIC Scalar Series Switch User Manual


 
Operation and Maintenance 33
What Happens When Door is Opened
Whenever you open the front door of the Scalar Library , the following actions occur:
l The library will return Unit Attention and Not Ready status to the host computer.
l Any function, if executed, that would change the state of the robotics machine is disabled.
Resuming Operation
To resume normal operation, close the door and lock it.
After the door is closed:
l The library will perform its power up checks.
l The application software may update its own cartridge inventory.
Drive Power-on Self-Test
When you power up your Scalar Library , the DLT drives each perform a Power-on Self-Test (POST) while the
library is performing the Power Up Checks. The sequence of events for each drive is:
1. The LEDs on the right front panel of the drive will turn on sequentially from top to bottom. All
LEDs will remain ON for a few seconds.
2. The LEDs on the left front panel of the drive will turn ON at the same time for about three seconds
and then turn OFF.
3. The Operate Handle, Write Protected, and Use Cleaning Tape LEDs will turn OFF. The
Tape in Use LED will blink while the tape drive initializes.
4 If your external SCSI bus terminator has a Term Power LED it should also be illuminated.