Filter
Top Products
Section 4, User Interface Guide ATLAS 550 System Manual
270 © 2002 ADTRAN, Inc. 61200305L1-1F
DIAL PLAN (T1/PRI) > NETWORK TERM (RBS) > IFCE CONFIG (RBS) > FGD TX SEQUENCE
Write security: 3; Read security: 5
Displayed only if SIGNALING METHOD is configured for FEATURE GROUP D. Defines to the ATLAS 550 the
format in which to present the outgoing digits. Choices:
NORMAL if no digits are to be sent; ANI/DNIS to
send both ANI and DNIS;
DNIS to send DNIS only; ANI to send ANI only.
DIAL PLAN (T1/PRI) > NETWORK TERM (RBS) > IFCE CONFIG (RBS) > FGD RX SEQUENCE
Write security: 3; Read security: 5
Displayed only if SIGNALING METHOD is configured for FEATURE GROUP D. Defines to the ATLAS 550 the
format in which to receive the incoming digits. Choices:
NORMAL if no digits are to be received; ANI/DNIS
to receive both ANI and DNIS; DNIS to receive DNIS only; ANI to receive ANI only.
DIAL PLAN (T1/PRI) > NETWORK TERM (RBS) > IFCE CONFIG (RBS) > WINK AFTER
ANI/DNIS
Write security: 3; Read security: 5
Displayed only if SIGNALING METHOD is configured for FEATURE GROUP D. When enabled, the ATLAS 550
will transmit a wink after ANI/DNIS digits are transmitted.
DIAL PLAN (T1/PRI) > NETWORK TERM (RBS) > IFCE CONFIG (RBS) > DIGIT SUPPRESSION
Write security: 3; Read security: 5
When enabled, no digits will be sent toward the network/PBX after going off-hook on an outgoing call.
DIAL PLAN (T1/PRI) > NETWORK TERM (RBS) > IFCE CONFIG (RBS) > DIRECT INWARD
D
IALING
Write security: 3; Read security: 5
Defines to the ATLAS 550 whether Direct Inward Dialing (DID) is being used by the network. If DID is
ENABLED, then the following information must be defined.
DIAL PLAN (T1/PRI) > NETWORK TERM (RBS) > IFCE CONFIG (RBS) > DID DIGITS
T
RANSFERRED
Write security: 3; Read security: 5
Defines the number of digits sent to ATLAS 550 from the network if DID is used. This option only displays
if
DID is set to ENABLED.
DIAL PLAN (T1/PRI) > NETWORK TERM (RBS) > IFCE CONFIG (RBS) > DID NUMBER PREFIX
Write security: 3; Read security: 5
Defines to the ATLAS 550 the prefix digits which are not received as a part of the DID number. The
ATLAS 550 uses the combination of prefix and DID number to determine the user endpoint that should
receive the incoming call. This option only displays if
DID is set to ENABLED. If DID is DISABLED, then you
The ATLAS 550 converts signaling types between network and user terminations.